Synchronizing several identical strobes
I need to synchronize 4 flashes. Infared, Optical and radio not
allowed. Just wire or sync cord connections. Too much interference
from others and other things. So wire is the only option.
Will my Canon 40D handle 4 flashes. Sync voltage on the strobe is 3.6
volts DC. Flashes are all the same - Interfit 150s. I can do the
wiring etc with no problem. Will a diode in series with each sync
lead, to avoid loading problems, be OK?
I should know all this stuff but have never needed to flash 4 flashes
using just cables/wire.
Thanks in advance
Bob AZ
.
Relevant Pages
- Re: Synchronizing several identical strobes
... Just wire or sync cord connections. ... Too much interference ... Flashes are all the same - Interfit 150s. ...
(rec.photo.digital) - Re: Anyone using a Wein safe sync on a Rebel XT?
... Thanks blah ... What is the voltage from the sync on the flashes? ... What does the Rebel XT manual say for sync voltage? ...
(rec.photo.digital.slr-systems) - Re: Wireless connections
... button on the hub until it flashes and then press the ... Follow the instructions and the dongle tries to connect ... Plug the hard wire back in and it's instantly communicating at 30 ... The Hub I've got works perfectly when wired and I suspect it's the other end of things where it all goes tits up when I attempt to go wireless, Going with wires is the most obvious solution and a new wire to my 2nd computer costs £6.95 and I only need it because my original wire is 2 metres short. ...
(uk.rec.motorcycles) - Re: Stripping 40 AWG/45 SWG or finer magnet wire/enamelled copper wire?
... Hold the end of the wire in a lighter or match flame until the varnish ... just flashes off. ... the wire thru the folded sandpaper, ...
(sci.electronics.repair) - Re: Stripping 40 AWG/45 SWG or finer magnet wire/enamelled copper wire?
... Hold the end of the wire in a lighter or match flame until the varnish ... just flashes off. ... the wire thru the folded sandpaper, ...
(sci.electronics.repair) |
|
