Re: xD transfer speed through printer to computer


"Tony Sivori" <TonySivori@xxxxxxxxx> wrote in message
news:pan.2006.05.07.17.33.01.136166@xxxxxxxxxxxx
Complete newbie here, I bought my first digital camera (Fuji FinePix F10)
yesterday.

How long should it take to transfer pictures to my computer?

I've tried two methods, both through my all in one printer (HP 2575
Photosmart) which has built in card readers and a built in USB 2.0 port.
My computer has no front USB ports, and the back ports are in use plus
they are inconvenient to reach.

Using the card reader in the HP 2575, transfer to the computer is
painfully slow, about 1 minute per 1.4 MB photo (it took 18 minutes to
transfer 16 1.4 MB photos).

So I tried the DSC (USB mass storage) mode using the USB 2.0 port on the
printer (the printer is networked on 100 MB ethernet, so that shouldn't be
a bottle neck). The results were the same. 18 minutes to transfer the
same 16 photos.

Is it normal to take so long?

I have available connectors on my motherboard to add front USB 2.0 ports.
I don't mind spending the money to add front USB ports if it will be a lot
faster to connect direct to the PC.

--
Tony Sivori


I find the Xd cards to be considerably slower than CF cards. Much slower.
Olympus C-7070 camera. It uses a CF card and a Xd card, the Xd card is
backup.

You might consider a USB hub instead of the front panel. I have a front
panel with 2 USB ports as well as some other ports. Its nice to have but I
can see that the USB port connectors are showing some wear. A hub is cheap
and can be tossed out if it gets bad.


.

Relevant Pages

  • Re: USB questions
    ... The purpose of the USB PC Cards is primarily to "upgrade" a PC that only has USB 1 ports to USB 2 ports, although obviously they can also be used to add more ports as well. ... The power jack on the cards, when present, is an input, without the input the card doesn't supply power to USB powered devices. ... Also, since what you need is 5 volts, supplies are fairly common and you do not need to use the supply, the supply cord or intended source that the card maker suggested ... ...
    (comp.sys.laptops)
  • Re: xD transfer speed through printer to computer
    ... Photosmart) which has built in card readers and a built in USB 2.0 port. ... My computer has no front USB ports, and the back ports are in use plus ... I decided to go the card reader route. ...
    (rec.photo.digital)
  • Re: usb flash drive locks up system??
    ... Seems usb conflicts are the first thing to check and if I'd found/remembered ... the scanner running usb, this problem would have been fixed immediately. ... I have a USB scanner plugged into pci usb card and that was ... have been known to blow out ports ...
    (microsoft.public.windowsxp.hardware)
  • Re: USB DEVICE NOT RECOGNIZED - ALL PORTS
    ... This seems pervasive, reading the USB comments. ... Does this PCI USB CONTROLLER go inside of outside of computer? ... card, would end up on the left hand side of this picture. ... to add five USB ports. ...
    (microsoft.public.windowsxp.hardware)
  • Re: High speed device plugged into non-high speed port
    ... > The motherboard has six onboard USB 2.0 ports that work fine. ... I then bought another VIA VT6202 PCI USB 2.0 card, ...
    (microsoft.public.windowsxp.hardware)
Loading