Re: Aristo cold head (Richard K.)

Richard, here a just a couple snapshots of two parts of the Saltzman. The
upper section of the snapshot shows the front lower with the large two
hand-wheels. Left is focus and right raises and lowers the whole head.

The close-up is the rear of one horizontal bar of the head section. Turning
the wheel moves the head forward and back. The other is exactly the same.
They were missing the gears, retainers, and spacers - everything but the
wheels. I haven't got the connecting chain yet (#40 chain, I think
ten-pitch). Got the hubs, spacers and gears at the tractor parts shop today.

It's hard to shoot snapshots in the shed. This was done with the doors open
to the 6pm MinneSnowta May sun.


.

Relevant Pages

  • 7.0-BETA1.5 Available...
    ... build machines used for the Monthly Snapshots and procedures in place to ... try and minimize the mistakes I could make while doing those Snapshots ... (previously one set for HEAD, ... important adjustment to the build routine while doing the BETA1 builds, ...
    (freebsd-current)
  • 7.0-BETA1.5 Available...
    ... build machines used for the Monthly Snapshots and procedures in place to ... try and minimize the mistakes I could make while doing those Snapshots ... (previously one set for HEAD, ... important adjustment to the build routine while doing the BETA1 builds, ...
    (freebsd-stable)
  • Re: 7.0-BETA1.5 Available...
    ... procedures in place to try and minimize the mistakes I could ... make while doing those Snapshots (previously one set for HEAD, ... The set of machines I'll be using for ...
    (freebsd-stable)
  • Re: 7.0-BETA1.5 Available...
    ... of build machines used for the Monthly Snapshots and procedures in ... place to try and minimize the mistakes I could make while doing ... The set of machines I'll be using for the 7.0-RELEASE ... build are the ones that had previously been doing the HEAD ...
    (freebsd-stable)
  • Re: 7.0-BETA1.5 Available...
    ... of build machines used for the Monthly Snapshots and procedures in ... place to try and minimize the mistakes I could make while doing ... The set of machines I'll be using for the 7.0-RELEASE ... build are the ones that had previously been doing the HEAD ...
    (freebsd-stable)