Re: Gen Set will not remote start

Did you make any voltage measurements? On the start/stop switch,
there should be voltage on both outside legs and ground on the wiper,
center pin. The voltage will probably be a little less than 12. The
switch grounds the appropriate lead to initiate starting and stopping.

I'd look at in this order,

The remote start connector disconnected at the generator
Bad ground at the switch(s)
Cut remote control wire near the generator

If you don't find the problem doing the above, then unplug the remote
control connector at the genny and check for 12 volts and ground on
the appropriate pins (see the manual). Try starting and stopping the
generator by jumpering the appropriate pin to ground.

If no luck there, then you're going to have to look inside the control
box. Odds are the problem isn't in the box, since the remote switch
simply parallels the built-in one.

John

On Mon, 29 Aug 2005 22:17:20 GMT, Matt Hamm <matthewthamm@xxxxxxxxxxx>
wrote:

>Thanks for the reply. I have already done that. Have taken apart the
>control area, and have found nothing out of the ordinary
>
>Matt Hamm
>matthewthamm@xxxxxxxxxxx
---
John De Armond
See my website for my current email address
http://www.johngsbbq.com
Cleveland, Occupied TN
.

Relevant Pages

  • Re: DENON AVR3300 no FM reception
    ... mode no IF signal is getting to pin 1 of the IC LA1265 so I belief ... that the little tuner block is at fault. ... does NOT provide the B+ and the Tuning Voltage is stuck at B+ value. ... need to know Type/PN of the SMD switch at PCB ...
    (sci.electronics.repair)
  • Re: IVC102 tests
    ... A colleague of mine is testing it under two conditions with pin 2: ... With switch 1 open the summing junction of the integrator is not ... pin 2 is floating or grounded in this case. ... I would expect to see the offset voltage on the output. ...
    (sci.electronics.basics)
  • Re: DENON AVR3300 no FM reception
    ... mode no IF signal is getting to pin 1 of the IC LA1265 so I belief ... that the little tuner block is at fault. ... does NOT provide the B+ and the Tuning Voltage is stuck at B+ value. ... switch +12 VDC when so commanded. ...
    (sci.electronics.repair)
  • IVC102 tests
    ... A colleague of mine is testing it under two conditions with pin 2: ... With switch 1 open the summing junction of the integrator is not ... I would expect to see the offset voltage on the output. ...
    (sci.electronics.basics)
  • Re: Designing A Boost Regulator
    ... voltage is 1V, and the built in transistor will take 50V. ... > OK lets assume you have a boost converter like the one in this ... > where S is the switch that controls the Duty Cycle. ... > So having done all this I then started into the PWM control of a boost ...
    (sci.electronics.design)
Loading