Re: Begineers question on Guitar action ?

On Fri, 08 Aug 2008 10:37:22 +0100, Dave <Davel@xxxxxxxxxxxx> wrote:

Hi

Hope this is not a stupid question, I am a begineer to guitar.

The strings on the old acoustic I have been given are 1mm above the
fret on the nut end of the fingerboard but about 6mm above the fret at
the body end.

I have recently looked at two electric guitars in a shop and these
also seem to have "a sloping fingerboard".

Is this correct, should the strings have the same clearance all the
way along the finerboard, if not, what is normal.

TIA


Dave

I think I did ask a partiality stupid question. Of course the
fingerboard has to have some slope, otherwise the strings would buzz -
hit the other frets.

But the sensible part of the question still stands, what would be a
reasonable clearance be at, say, the 12th fret. I think 6mm about 7/32
is a bit high ?.

Dave
.

Relevant Pages

  • Re: High action on an acoustic
    ... For more tips on destroying/repairing your acoustic guitar: ... Remember the "saddle and the bridge"? ... I think the truss rod is ok because between 1st and 12th fret the ... by adjusting the truss rod with the strings off. ...
    (alt.guitar.beginner)
  • Re: SOT: Tastes in Music
    ... only the note they are playing and leave the other strings open. ... others think it is part of playing the acoustic guitar, ... I hate fret noise, and for me it just shrieks of poor technique. ... intuitively in those as they do in standard tuning. ...
    (uk.rec.audio)
  • Re: correct neck setup for an archtop guitar
    ... I had adjusted the truss rod on my Hollenbeck only once after I had it about 2 years and that was 12 years ago. ... Then through the years you may need to snug it a bit but a good solid made guitar it may happen very little. ... I have also had to loosen it once after I tried some bigger .13 to .54 strings. ... I actually had to take off a fair amount of fret as the fingerboard did move a bit up on the extension. ...
    (rec.music.makers.guitar.jazz)
  • Re: Solidbody guitar setup - What step did I miss?
    ... Some of it has to do with the construction of the guitar itself, and some of it has to do with how hard you fret your strings. ... And then lastly, I mentioned that I put straplocks on it and that the screw that was supplied with the straplocks were much smaller than the hole in the guitar and that I had to use 4 toothpicks in order for the screw to grip, and he said that was typical of aftermarket screws. ...
    (rec.music.makers.guitar.acoustic)
  • Re: Fretting in the middle and string buzz
    ... playing an instrument with 'floyd rose' bridge. ... not in a very good condition, strings are rusty, got some string ... He agreed as long as I won't break the guitar completely. ... to play due to high action at 10th fret and further. ...
    (alt.guitar.beginner)
Loading