Re: 1967 Chet Atkins "Tennessean" Gretsch Repair Question
- From: Mattia Valente <mae.valente@xxxxxxxxx>
- Date: Mon, 06 Mar 2006 18:25:16 +0100
Art Robb wrote:
Hello,
I have a 1967 Chet Atkins "Tennessean" Gretsch in the workshop
as the electronics are a little bit erratic. I'd like to check
out all the connections etc.
There are no soundholes. As I see it, either the back has to come off
or all components have to come out through pickup holes.
Anyone done this before? What's the most sensible approach?
I've built a few guitars where the electronics were all fed in through the bridge pickup cavity/hole, but that's about the extend of my expperience. Tie some fishing line or similar (stiff is best, that doesn't tangle too much), and tie the other ends together (so you don't loose the string going through the holes), and go finshing.
Mattia
.
- Follow-Ups:
- Re: 1967 Chet Atkins "Tennessean" Gretsch Repair Question
- From: Nick Odell
- Re: 1967 Chet Atkins "Tennessean" Gretsch Repair Question
- References:
- 1967 Chet Atkins "Tennessean" Gretsch Repair Question
- From: Art Robb
- 1967 Chet Atkins "Tennessean" Gretsch Repair Question
- Prev by Date: 1967 Chet Atkins "Tennessean" Gretsch Repair Question
- Next by Date: Re: 1967 Chet Atkins "Tennessean" Gretsch Repair Question
- Previous by thread: 1967 Chet Atkins "Tennessean" Gretsch Repair Question
- Next by thread: Re: 1967 Chet Atkins "Tennessean" Gretsch Repair Question
- Index(es):
Relevant Pages
|