Re: 1982 Honda CB 650 -- Electrical / Charging problems (as usual)

how do i do that? trace out the wires and make sure its passing 12
volts?

.

Relevant Pages

  • Re: SCA-2 Testing Bus
    ... forpower. ... I didn' trace all the wires, most were 12 and 5 volts, but ...
    (comp.periphs.scsi)
  • Re: Tech: Addams Family motor test question
    ... I do not measure any power at the motors. ... I will trace the wires back to the board and look for some ...
    (rec.games.pinball)
  • Re: 2 amps together buzzing?
    ... >Dave Curtis wrote: ... neutral has volts on it referenced to ground. ... The spacing of wires in BX is quite uniform. ... You're mixing Signal gnd with equipment gnd. ...
    (alt.guitar.amps)
  • Re: Onan Generator low operating voltage
    ... Final resolution in the low volts saga: ... Replaced the shore power plug and brought the voltage drop down to ... pulled the wires in the junction box in the rear bumper ... the genset does indeed put out an adequate voltage even with 2 ...
    (rec.outdoors.rv-travel)
  • Re: Grounded circuit troubleshooting
    ... My post of AC or DC was a valid query, since though the discussion centered on automotive systems, we were also talking up to 300 volts, well beyond what would be commonly found in automotive systems. ... Differential voltage measurements between two AC voltages bring into play a plethora of variables that the casual observer would'nt anticipate. ... Touch the wires to two pices of metal and if a current is flowing it will illuminate the bulb. ... between 300 volts and earth ground or neutral safety bus, ...
    (rec.autos.tech)