Re: 1982 Honda CB 650 -- Electrical / Charging problems (as usual)

hehe, well, its *supposed* to be a fuse there, but the previous owner
just hooked up a piece of wire to bridge the connectors where the fuse
would go.

.

Relevant Pages

  • Re: PCB of garage door opener failed: Which PIC is this?
    ... That´s what I was convinced too up to the day when the bulb was blown ... external connectors (i.e. actually only the ones which interface to ... I would be glad if there was that fuse ... soldered a piece of wire instead of the fuse holder. ...
    (sci.electronics.repair)
  • Re: Ping LZ
    ... used regular blade connectors, crush connectors, ground, filed, bent, ... you could do what I'm trying to stop doing: Tap a wire ... cheap knockoff Channel-lock that works best. ... The connector I shoved into an empty fuse slot is http://tinyurl.com/gp54d ...
    (rec.outdoors.rv-travel)
  • Re: Tech help: Stern LIGHTNING
    ... Can someone with a LIGHTNING take a picture of the J1 jack, on the rectifier board, down by the transformer, and indicate wire colors, please. ... Does the fuse blow without the PF connected and do you have voltage at the test point if not. ... I'd just replace the bridge, you should heat sink it as what you have pictured has no heat sink and all the bridges need it on this style of power supply. ...
    (rec.games.pinball)
  • Re: EM TECH: 1973 Williams Travel Time Startup issues
    ... Sure sounds like you have a bad Bridge there if it's the 10A solenoid ... bus fuse on the relay board that is blowing. ... Then you can connect the black wire to ... Check around the pop bumper assemblies to make sure that the leads ...
    (rec.games.pinball)
  • Re: Tech help needed on Black Hole
    ... bunch of spare parts, caps, and connectors. ... bad diode it will not do so with the fuse removed. ... your voltages on the power supply board. ...
    (rec.games.pinball)