Re: 1982 Honda CB 650 -- Electrical / Charging problems (as usual)




Rob Kleinschmidt wrote:

You ought to start by making sure the battery is good.
Sounds like you already have a multimeter. Charge the
battery with a charger and test the voltage. A good shop
can also test the specific gravity and/or load drop and will
do this as a courtesy as part of selling new batteries.

A sulfated battery will charge up to the recommended voltage and the
specific gravity will show the battery is fully charged while it
actually only has a surface charge on the
plates. It will fail the capacity test.

All that's necessary to do the capacity test is to hook a motorcycle
headlamp across the battery terminals. A 55-watt headlamp will draw 4.6
amperes.

If the battery in question is a brand new fully charged 12 ampere hour
battery, it should light the headlamp for 12 / 4.6 = 2.6 hours without
the voltage dropping below 12 volts.

.



Relevant Pages

  • Re: Some quick questions about cells and batteries...
    ... Every battery chemistry requires its own unique ... manner of charging (and sensing when a charge is finished). ... reach a certain voltage, and then charged at constant voltage there-after. ... damaging the cells and/or creating a fire. ...
    (sci.electronics.basics)
  • Re: How to charge a 9V Ni-MH
    ... Battery is 9V, 150mAh. ... you *must* use a regulated voltage source. ... at least 3 volts higher than the full charge voltage ...
    (sci.electronics.design)
  • Re: Battery charging with intermittant power source
    ... For this method I need a constant current, until the charge voltage is ... For this I would set the current limit to the maximum battery charging ...
    (sci.electronics.design)
  • Re: Battery charging with intermittant power source
    ... For this method I need a constant current, until the charge voltage is ... For this I would set the current limit to the maximum battery charging ... That the power will be on for the fixed time. ...
    (sci.electronics.design)
  • Re: Charging lead acid batteries.
    ... Terminal voltage can be very useful for charge determination of Lead Acid ... If the battery is left standing for several hours, ...
    (sci.electronics.design)