Re: BDL 3" Belt Drive Installation Question


derch wrote:

> 3) When installed, should the front pulley seat and totally cover onto
> the teeth in the cam? In other words, when I attach the locking bolt,
> there is not enough of the cam shaft for the bolt to thread on.
> Any help would be appreciated. Thanks All.

I think I figgered out where all yer problems are coming from.....if
yer trying to bolt that shit onto the cam shaft, ya got it on the wrong
side of the engine...

--
Big Ben

.

Relevant Pages

  • Re: Terribly lacking in details post about a scroll saw.
    ... If the shaft bolt has wear, a new one should be run in. ... The bushing would be bored to fit the diameter of the bolt. ... It would be great to use ball bearings, if the cam is thick enough. ... machine-shop work, and I doubt it would come cheaply. ...
    (rec.woodworking)
  • Re: Q. re. 96 Corolla CAm Timing Mark
    ... Whichever sprocket hole has both no. 1 cyl. ... Look at the cam lobes, ... breaking free the harmonic balancer bolt. ...
    (rec.autos.tech)
  • Terribly lacking in details post about a scroll saw.
    ... It would appear that the bolt that serves as the, ... term, "axle" for the cam is a bit worn, and so is the hole in the cam. ... and make the bolt nice and solid, but there is still a fair amount of ... I would like to fix this ...
    (rec.woodworking)
  • Re: engine compatibility
    ... And they use bronze freeze plugs instead of steel. ... would probably have a cam closer to the marine one. ... I've never heard of a 4 bolt 4.3. ... could be some different casting variations. ...
    (rec.boats)
  • Re: New toy!
    ... # # I'd expect the bolt would never lock up, so the firing pin wouldn't get ... # by much larger Giant Pulsating Brains than I have, to fire an AR with no cam ... # pin installed. ... carrier group without the cam. ...
    (rec.guns)