Hacker A20-20L with X20 ESC

Hello,
yesterday I picked up the above motor and ESC. As I look at the
instructions manual I do not see any information on how the wires are
supposed to be connected toghether. I don't see any markings on the
wires and they're all black. Any suggestions from the experienced users
out there?

Thanks in advance,
Matt

.

Relevant Pages

  • Re: ezilla to accept ladder packs
    ... Above is what I was planning on doing to my Savage when my motor ... and the roller (no electronics) cost him $1200 used. ... I recon if that guy moved his esc to the front of the chassis, ... replaced the motor and battery wires. ...
    (rec.models.rc.land)
  • Re: ezilla to accept ladder packs
    ... My 2 pairs of matched 3300mah batteries give me ... I recon if that guy moved his esc to the front of the chassis, ... where the receiver was and running 2" long wires to the motor, ... replaced the motor and battery wires. ...
    (rec.models.rc.land)
  • Re: Problem with brushed motor
    ... Another thing to try is wrapping the ESC RX wires around a ferrite ring just ... the 400-series electric motor begins to "miss" ... Next get the ESC WELL away from the receiver, ...
    (rec.models.rc.air)
  • Re: Hacker A20-20L with X20 ESC
    ... yesterday I picked up the above motor and ESC. ... wires and they're all black. ... The normal direction for most props is CCW. ...
    (rec.models.rc.air)
  • Re: ezilla to accept ladder packs
    ... wires and 20 cm's of wires. ... they are a huge bottleneck in your electrical system. ... (bottleneck between batteries to esc and bottleneck between esc to motor) ...
    (rec.models.rc.land)