More on current draw of glow plugs



It varies from plug to plug.
I had a twin with 2 inverted engines and wired an onboard glow starter with
a 3 volt battery and the plugs in series. It worked fine for years until I
changed a glow plug and it had a different resistance from the other. The
plug with less resistance did not light up.


.



Relevant Pages

  • Re: Measuring glowplug under voltage
    ... To ignite the heater they use a combined glowplug/flame sensor which is ... The voltage to the glow plug is cut and the glow plug ... acts now as a flame sensor by measuring the temperature. ... Put a square DC to the plug and measure resistance every time the ...
    (sci.electronics.design)
  • Re: Laptop trips GFI
    ... These devices use disk ceramic capacitors that frequently develop troublesome leakage resistance. ... You may have a salty moist sweat stain on plug terminal, wire, grip, etc, to some earthed part of the boat. ... It seems unlikely there is an electrical contact on the case of the laptop that might be in contact with an earth or even your hand, but that too would only indicate an internal leakage through the power supply or charger, which could be lethal, if circumstances get right. ...
    (rec.boats.electronics)
  • Re: New to glow plugs and diesel engines!
    ... If it is a healthy plug, there should be resistance measured. ... this would indicate a broken element. ... connection on, hold each plug against the engine metal body, have someone ...
    (uk.rec.cars.maintenance)
  • Re: Best professional soldering iron??
    ... the plug, but that would be something to look into there. ... Double the voltage, fixed resistance, 4 times the wattage, burn your hand ... For resistance loads that don't need a neat wave form, ... but check in an electronics store near you, ...
    (rec.crafts.glass)
  • Re: Some pics of the new Revo!
    ... "compression" escape or releasing it's resistance.. ... They all turn over easy with the plug out..atleast everyone I have ... The K46 is an ABC engine so the piston and sleeve expand at ... But for its whole life its been hard to get a nice tune. ...
    (rec.models.rc.land)