Re: Ground Throws

place a small amount of balsa glue on each nail or pin or for that matter
into the hole used to secure the ground throw it should work as a packing
agent in the hole and harden in the hole. I would use a small pair of
pliers and notch the nails or pins to give them an irregular shape more for
glue to harden over.

but thats what I'd do


mick
"Jeff Stanton" <jstanton@xxxxxxxxx> wrote in message
news:11e5i9jjh1lgmfd@xxxxxxxxxxxxxxxxxxxxx
>I have a small problem. I need to install a number of ground throws on two
>surfaces that do not hold nails well. One is homosote, and the other is
>foam. Does anyone out there have a trick for doing this?
>
> Jeff
>
>


.

Relevant Pages

  • Re: Stuck extractor pin in Sig P229
    ... While re-assembling my P229 extractor, ... which pushed the pin further down into the hole. ... Find mild steel rod that is a LOOSE fit in the hole. ...
    (rec.guns)
  • White Water WH2O Pin on CL in Somerset Wisconsin
    ... To say he misrepresented the pin ... and wire guide where the ball kicks out. ... upper ramps are cracked to the point where the upper flipper if not ... the hole is that big. ...
    (rec.games.pinball)
  • Re: Reamers
    ... tapered rim for the press fit. ... an undersized drilled hole is to tap it. ... When you don't need a hardened pin it's a lot easier to ream the hole ... You can make a drill bit enlarge a slightly undersize hole to size ...
    (rec.crafts.metalworking)
  • Re: pin/hole strength calculation in telescoping legs?
    ... yield strength of a hole, you just use the diameter times the thickness, ... which is a smaller area than half the surface area of the hole, ... with the pin going through both sides, ...
    (rec.crafts.metalworking)
  • Re: White Water WH2O Pin on CL in Somerset Wisconsin
    ... ÊI don't think he was trying to as he was not pin ... and wire guide where the ball kicks out. ... upper ramps are cracked to the point where the upper flipper if not ... the hole is that big. ...
    (rec.games.pinball)