Re: How to scope old 22 rifles.
I wouldn't do it with a hand drill. The screws need to be perpendicular,
spaced correctly and not to deep. Then tapped so the mounts can be screwed
down. I would check with a gunsmith it shouldn't be too expensive,
especially if the gun is in good shape. The e2 22s I have are about 30 years
or older, and they have groves on the receiver for 22 scopes
Frank
"leo3006" <Lrozycke@xxxxxxxxx> wrote in message
news:fkdn8b$m4u$1@xxxxxxxxxxxxxxxxxxxxxxxx
...
-------------------------------------------------------
Learn about rec.guns at
http://www.recguns.net
Win a Fulton Armory "Predator" AR-15 accuracy rig while
supporting our RKBA. Details at
http://www.myguns.net
-------------------------------------------------------
.
Relevant Pages
- [SLE] Need Hardware Storage Device Info
... the effort of screwing the drive down onto the mounts. ... it might have some simple thumb ... screws, slip the cover over it, and plug it in and use it. ...
(SuSE) - Re: Mirror Mount Question
... Unfortunately, I already have a few kinematics mounts but, as I mentioned in my OP, these aren't ideal if you only want to move the mirror in one plane - as in tilting 'forward' to produce fringes from the fully compensated position of a MI. ... My "three screws in a triangle" comment is a mount has the spring-loaded screws in an equilateral triangle with one screw at the top centre of the plate that is set by the screws - this is the one you use to tilt the mirror forward for fringes. ... I'm using 1" square mirrors and a 1" cube BS and tried using Edmunds mounts for the mirrors, but I now realise that these are kinematic mounts and are not really suitable for what I want. ...
(sci.optics) - Re: Mirror Mount Question
... these aren't ideal if you only want to move the mirror in one plane - ... My "three screws in a triangle" comment is a mount has the spring-loaded ... mounts for the mirrors, but I now realise that these are kinematic ... translation stage, and a micrometer screw assembly for the stage. ...
(sci.optics) - Re: Beyer M160 Grill Removal
... aren't very deep. ... I also think they may have some sort of locking ... well equipped shop and a full set of Wima screwdrivers. ... the screws came out. ...
(rec.audio.pro) - Re: dashboard falling apart
... The dashboard's mounts are disintegrating! ... The radio is being held by two threads of plastic, and when I went to turn the screws on the AC control's mount, plastic went flying. ...
(rec.autos.makers.chrysler) |
|
