Re: Scope for Marlin 39A
On that vintage, they only had side-holes for peep sights.
Newer variations had holes in the receiver top.
I would strongly encourage you to refrain from drilling the old girl unless
she's beat to heck.
I'll even offer to buy it so you can get a newer variation with the top
holes you desire.
"Wayne" <mygarbagecan@xxxxxxxxxxx> wrote in message
news:dr4cnn$503$1@xxxxxxxxxxxxxxxxxxxxxxxx
> ...
--------------------------------------------------------------------------
Win a Fulton Armory AR-15 rifle and protect your 2nd Amendment Rights too!
See details at
http://www.myguns.net to support MPFO!
Learn about rec.guns at
http://www.recguns.net
--------------------------------------------------------------------------
.
Relevant Pages
- Re: Uni-Tee
... Not only does mine have the holes for the 3 handles, ... This allows you to interchange the camera and eyepiece without ... > I used a couple variations of this focuser on a Newtonian. ... > After using helical focusers for years, my wife's scopes convinced me to ...
(sci.astro.amateur) - 95 and newer variations FS
... and have some holes in your collection ... from #1 blue card up to current day...shoot me a list of wants. ... over 4,000 cars up for grabs, and a lot of them are vhtf variations. ... I won't be able to send out lists of what I have, ...
(rec.toys.cars) - Re: Mystery tool
... the holes then used to show what material to remove, ... drilling or profiling rims. ... inside of a rim blank. ... to a profile cutter) or has stops (for drilling holes at intervals). ...
(rec.bicycles.tech) - Re: Mystery tool
... the holes then used to show what material to remove, ... inside of a rim blank. ... to a profile cutter) or has stops (for drilling holes at intervals). ... onto the carriage of a lathe with a spoke hole sized drill bit in the ...
(rec.bicycles.tech) - Re: Forstner bit recommendations
... I got maybe half a dozen clean, easy holes. ... improvement or is a bit in that price range likely to be from the same ... You should be drilling at 400 ... I have an old set of Trendlines Forstner bits make in Germany that have been ...
(rec.woodworking) |
|
