Re: Tempest and Defender Help - Washington State
- From: James Sweet <jamessweet1@xxxxxxxxxxxxx>
- Date: Fri, 02 Jan 2009 12:13:40 -0800
darkrpa@xxxxxxxxx wrote:
My Tempest monitor is showing only "red" vector lines and is squished
in the middle of the screen about 3 inches high or less. This monitor
was not working at all about a year ago and i had it repaired then and
at install i had this problem at powerup then.
Are you sure the boards are putting out the correct signal? This could easily be either a board or a monitor problem, and it sounds like two independent problems, the color drivers are separate from the deflection circuitry.
My Defender at powerup, just makes the bootup sound about every 20
seconds or so and i get the scrolling "rug pattern". I at that same
time, had the boards looked at, when i had the Tempest monitor fixed.
Do you get any errors on the display (or is it just LEDs on Defender) when you power it up? Power supply voltages all good?
.
- References:
- Tempest and Defender Help - Washington State
- From: darkrpa
- Tempest and Defender Help - Washington State
- Prev by Date: Tech: Tempest Main board Repair Interesting Problem
- Next by Date: Re: FS/FT: Defender Prototype $500-TX
- Previous by thread: Tempest and Defender Help - Washington State
- Next by thread: WTB LaserAce Card
- Index(es):
Relevant Pages
|
