Re: Using Sanyo 20EZ with non Nintendo game?

On Feb 11, 10:24 am, Brad Thompson <btho...@xxxxxxxxx> wrote:
On Feb 11, 6:02 am, "super_sto...@xxxxxxxxx" <super_sto...@xxxxxxxxx>
wrote:





On Feb 11, 8:15 am, Rob Carroll <robert.carrol...@xxxxxxxxxxx> wrote:

On Feb 10, 11:59 pm, Brad Thompson <btho...@xxxxxxxxx> wrote:

Hey,

Just wondering I want to use a Sanyo 20EZ with my robotron game.  What
mods are required?  Something about inverted colors or something? Any
good sites out there explaining this process?

Thanks,

Brad

I'd bet there are some guys out there trying to restore a Nintendo
game that would gladly trade you another monitor for your Sanyo.

I would :)
I know Zanen Electronics sells an inverter board for the input and I'm
sure I have a Nintendo transformer here somewhere.

Well if someone lives in Vancouver Canada and has another say G07 they
want to trade with no burn in then I'm all for that but I'm sure
shipping these monitors is kind of a pain.  Thanks for all your help I
will go find a inverter board.- Hide quoted text -

- Show quoted text -



I have an old 20EZ from a DK. Maybe I am stupid but I hooked it up in
another cab with 120vac to it and it worked fine. I had to adjust the
colors a bit on the monitor but it runs fine.
Jim
.

Relevant Pages

  • Re: Using Sanyo 20EZ with non Nintendo game?
    ... game that would gladly trade you another monitor for your Sanyo. ... I know Zanen Electronics sells an inverter board for the input and I'm ...
    (rec.games.video.arcade.collecting)
  • LCD monitors Inverter bad ?
    ... The monitor has two backlights, one at the top and one at the bottom. ... It appears that the bottom CCFL is the one that used to be lit up ... The inverter has 4 wires going to it from the "motherboard" of the LCD ...
    (sci.electronics.repair)
  • Re: LCD monitor problem
    ... If I switch the monitor on ... I have a samsung TV that's not even 3 years old, and the power board has ... leaky caps on it!.. ... rekon inverter.. ...
    (uk.comp.homebuilt)
  • Re: LCD Monitor 15" with backlight problems
    ... the monitor even shut off lamps (but picture ... i realized that backlight inverter pcb has completely ... Now I found on Ebay some backlight inverter that should work with my monitor ...
    (sci.electronics.repair)
  • Inverter shutdown occurs on Dicon/Nextview 17" LCD monitor from 455MHz rf signal. Design flaw?
    ... knocking out the backlight on this monitor. ... cycled before the inverter starts up again. ... inverter itself - the TFT controller does *not* drop the enable signal to ... I suspect that the O2 micro OZ960 chip on the inverter is ...
    (sci.electronics.repair)