Re: TECH: +/- 10% reisistor question--Will +/- 5% work?

Cool! That's exactly what I needed to know. Thank you!

jaysun

On Jan 24, 5:37 am, "pe...@xxxxxxxxxxxxxxxxxxx"
<pe...@xxxxxxxxxxxxxxxxxxx> wrote:
Agreed. You could always buy like 10 of them (you might have to
anyway), and just pick the resistor out of the 10 that meters the
closest to .27 ohm. At .27 ohms, 5% or 10% is such a small amount that
it probably won't matter anyway.

.

Relevant Pages

  • Re: Jefimenkos mistakes
    ... Was one end of the resistor grounded? ... I doubt very much that any magnetic coupling via the air transformer route is the source either. ... you said .5 millivolts over 5 meters based on J's calc. ... i is current; L is length of conductor; R is distance from conductor at the center of the two ends of L; and k is a unit direction vector that points in the direction of the current. ...
    (sci.physics.electromag)
  • Re: Contact Thermometer for Component Temperature
    ... on the heat from a 1206 resistor on a high density pcb? ... SMT electronics need. ... things that are meters across and many meters away. ...
    (sci.electronics.design)
  • Re: R not R anymore..
    ... George Herold wrote: ... Repeat cleaning scheme followed with PFA and same cycle with air dry. ... resistors inside the GR meters need cleaning?* Do both meters read ... All scales are done the same way: Rx is the top of a resistive divider; the bottom resistor is changed for the scale. ...
    (sci.electronics.design)
  • Re: multimeter question
    ... > an example would be measuring a 10k resistor in-circuit. ... > im guessing that is because the meters i have use 3.3v across the leads ... Most likely reason for different readings when the ...
    (sci.electronics.repair)
  • Re: R not R anymore..
    ... resistors inside the GR meters need cleaning?*  Do both meters read ... the bottom resistor is changed for the scale (1Meg..100,000Meg ... is measuring 6gig. ...
    (sci.electronics.design)