Re: K6100 spot killer still on after cap and Transistor kits

Well actually the 4 diodes for the low power section were ok they are
very Large. Maybe Bob has changed the type of diodes he had used
before??

The one that was bad was the small one next to the Q103 (I think , no
schematics in front of me). I think it was a 1n4001??

But anyways, let me play the game for a few days and see what holds
and what does not.

Thanks

Jay

.

Relevant Pages

  • Re: finding obsolete components??
    ... >> one to find current equivalents to discontinued parts? ... with a laser. ...
    (sci.electronics.repair)
  • Re: 0.20 delay in 6v control circuit
    ... >Bob wrote: ... >> Do you have any idea on the specs for the diodes needed. ... >> design. ... Anyway I built the circuit as you designed. ...
    (sci.electronics.basics)
  • Plasma Therm Parts
    ... Anyone using a Plasma Therm RIE? ... I need some diodes for a read out module SEV 2DC. ... Bob ...
    (sci.engr.semiconductors)
  • Re: TECH: Chronic Driver Transistor Failure on Gottlieb Sinbad
    ... I just installed a replacement MPU and driver board from Ni- ... I snipped off the diodes and measured them with my DMM. ... the coils, ... pinrepair guide for info on this and how to check your game. ...
    (rec.games.pinball)
  • Re: False Slam Tilts on Williams WPC Demolition Man
    ... my buddy is playing a game cranking demo man to ... After that I go to every switch on that row, ... *then* go back and start testing diodes to check ... how to test them w/o desoldering. ...
    (rec.games.pinball)