Re: Putting a Switcher in Qix

Thanks for the info, it really helps.

Any chance I hooked it up wrong? The MRST line is supposed to go to
+5 on the power supply, right (with diode and resister in between)?
And the capacitor is hooked up to the ground on the Power supply?
Still having some problems, I thought the switcher would fix it.
Graphic card LEDS are lighting, have to check voltages to other boards
yet.

This is what it looks like, right?:

-5
+12
GND
GND-----CAP--|
v
+5V---- < --Diode/Resister--<---MRST


???

Again, thanks for posting this.

- Ryan

.

Relevant Pages

  • Re: Tech... South Park issue
    ... do you think there is a chance the diode on the coil that pulls him ...
    (rec.games.pinball)
  • Re: Byte swapping help please
    ... Not a chance. ... have any noise margin left, in fact it will be negative. ... VCEsat and a diode drop? ...
    (comp.arch)
  • Re: wiring up LEDs for in-house use
    ... wire LED's in parallel with a 100ohm resister to each ... They will only pull about 15mA each if you power with a cheap 5v ... couple IR sensor and IR diode at the top and bottom of the stairs and when ...
    (sci.electronics.basics)
  • Re: Sharp Microwave powers down after 40 seconds, need assistance
    ... I'll remove the diode and give the circuit a quick voltage ... Any chance I could damage the LC4061 by pulling the diode and putting a ...
    (sci.electronics.repair)
  • Re: TECH: Demolition Man
    ... Install the diode and check the drive transistor. ... good chance the drive transistor is toast. ...
    (rec.games.pinball)
Loading