Re: TECH: Pacman on Test Bench and 7vac?


dmillikan@xxxxxxxx wrote:
Connect +5V into pins 5 & E, then put a strap across the 4 ohm 10W
resistor,
connect +12V to one of the 12VAC inputs, the 12V will take care of
itself.
Dick

barakawins wrote:
Going to attempt a board repair on a pacman. Question I have is pacman
takes 7vac input at the edge connector. On a test bench running as
switcher, how would you run the power to the harness?

john

Thanks a bunch!!!!
John

.

Relevant Pages

  • Re: TECH: Pacman on Test Bench and 7vac?
    ... connect +12V to one of the 12VAC inputs, the 12V will take care of ... barakawins wrote: ... takes 7vac input at the edge connector. ...
    (rec.games.video.arcade.collecting)
  • Re: TECH: Pacman on Test Bench and 7vac?
    ... Scott Caldwell wrote: ... barakawins wrote: ... connect +12V to one of the 12VAC inputs, the 12V will take care of ...
    (rec.games.video.arcade.collecting)
  • Re: Wire wound resistors and the worlds dumbest amp mod
    ... Don't care what 'WDAM' you say. ... buy the $25 'green' CD sharpie that was just a $.79 green Sharpie ... resistor in either game, so you buy some $.05 crap because of 'math'. ... the folks I fix/design amps for deserve better then that. ...
    (alt.guitar.amps)
  • Re: Pac board stuck in test mode
    ... The TEST input on the edge connector is pin K. This goes to a 1k pullup ... resistor pack at RM7; a discrete resistor at R44, ... First thing I recommend looking at is the .1uF capacitor at C19. ...
    (rec.games.video.arcade.collecting)
  • Re: Prevent signal when device is turned on
    ... resistor and the 0V. ... Okay, I see how that takes care of things while the signal is briefly ... the capacitor then discharge via the Base-Emitter? ...
    (sci.electronics.basics)