Re: K7000 repair question

Thanks - next dumb question: what's the best way to do that? No pins appear
to be shorted together (tried a DMM on it in-circuit), and it doesn't look
burned or anything. I know how to test a 3-legged xistor but I quickly get
out of my understanding in cases like these.

be sure to verify that ic4 is ok.



.

Relevant Pages

  • Re: GI Problems
    ... It's not a dumb question if you don't know. ... measure hot to common. ... Common issues is usually blown GI fuse, or connector burn - which you then ... If you replace the pins on the board, before putting the board back in the ...
    (rec.games.pinball)
  • Re: Sony KV32S22 - half-way back from the dead - what now?
    ... I would NOT try to measure the C of the HOT with a DMM. ... There should be two pins on the CRT socket labeled "H". ... be low resistance between these two pins on the socket with the CRT ...
    (sci.electronics.repair)
  • Question about PRIVATE_FUTEX
    ... I am not expert about futex. ... I am sorry if this is dumb question. ... which pins page at page table. ... Please read the FAQ at http://www.tux.org/lkml/ ...
    (Linux-Kernel)
  • Re: Addams Family major problem
    ... lead on the ground strap, ... DMM was set to DC. ... to see that kind of voltage ... ALL THE OTHER PINS READ AROUND 20V. ...
    (rec.games.pinball)