Re: Centipede, - 5v died, and now what????

I fixed the Ar2 board, by putting in a new -5v regulator, now I have all
the volts ac and dc, but the game board is not working now. I am
wondering what might have gone wrong on the pc board ?
I donot have a scope , but have access to one. What chips should I start
with?
thanks
Jay

--
Sent via Gamer Newsgroups
http://www.gamernewsgroups.com
.

Relevant Pages

  • Re: TECH:Rottendog Data East Power Supply DPS004 + older DMD
    ... put the DMD in another machine and it worked fine. ... The voltage on the output of the LM317 will be 1.5 volts. ... regulator available or it probably would have been the first choice. ...
    (rec.games.pinball)
  • QRe: Bearcat Repairs
    ... through a dozen changes at the time the drawing was made. ... volts, a good portion of the circuitry in the radio will not operate. ... regulator feeding into a 1 amp diode. ... I was eliminating all the parts as the book lists as suspects. ...
    (rec.radio.scanner)
  • Re: TECH:Rottendog Data East Power Supply DPS004 + older DMD
    ... The datasheets max voltage is 60 volts. ... regulator available or it probably would have been the first choice. ...
    (rec.games.pinball)
  • Re: AC->DC converter question
    ... Use a 7805 for the 5 volts, ... and power only one regulator at a time, ... I'd drop the voltage between the wall wart and the ... that would be about .96 watts ...
    (sci.electronics.design)
  • Re: Bearcat Repairs
    ... dozen changes at the time the drawing was made. ... volts, a good portion of the circuitry in the radio will not operate. ... can try replacing the Q204 regulator with a 9 volt three terminal regulator ...
    (rec.radio.scanner)