Re: Tech: Question about K7000 25" monitor

Usually when you put one of the caps in backwards you end up popping
the cap. Sounds like you have a bad critical safety cap(s). Or a bad
regulator. Pin 1 to 3 should show open on the regulator. There are 3
rectangular caps on the circuit board located by the H out transistor.
Lift one lead and measure them with an ohm meter.
The H out might be shorted also. You will have to remove it from the
circuit to test.

Rj

.

Relevant Pages

  • Re: Th HAT LADY 199? ......
    ... She ranted about kids wearing caps on backwards. ...
    (soc.retirement)
  • Re: Why not make the sensor larger?
    ... put their baseball caps on backwards? ... riflemen turn their caps around too. ... fad to do so is stupid. ...
    (rec.photo.digital)
  • Re: Mallory caps in epi lp studio
    ... and gibson used .047 because they wanted more treble, ... Otherwise why all those .047 caps in les pauls? ... backwards on the values just as you suggest. ... In a guitar the tone caps are dumping part of the signal to ground, ...
    (alt.guitar)
  • Re: Advent 300, NTE 188, ECG188, 2SC1628, MPSU06, MPSU04, = NTE190 ?
    ... Thanks for the help guys, got it up and running, some noise issues, I ... put in all new caps (probably one is in ass backwards), ... > Puerto Vallarta, Jalisco, Mexico. ...
    (sci.electronics.repair)
  • run/start caps
    ... phase motor is popping start caps. ... is there a reason that run caps shouldn't ... and the frequent starting may be the cause of the problem. ...
    (rec.crafts.metalworking)