Re: Tech: Question about K7000 25" monitor

Make sure you have the insulator between the HOT and the heat sink. If
you don't that could be the cause of your problem.



On 28 Nov 2005 19:54:21 -0800, "Don NJ" <piiifast@xxxxxxxxxxxxx>
wrote:

>I have a k7000 25" monitor that the flyback went on. I ordered the
>complete overhaul kit from bob roberts and not it blows the fuse. Can
>someone check there k7000 and let me know if there are any caps that
>are mounted reveresed to what's on the board silkscreened?
>
>Thanks,
>Don

.

Relevant Pages

  • Re: BDMICRO REACTOR RX50 H-Bridge (was Motor Controllers)
    ... electrically conductive heat sink, you'd have a short circuit within ... Look for the white insulator around the screw. ...
    (comp.robotics.misc)
  • Re: AppleColor Composite Caps
    ... period about 50% had their motherboards replaced due to bad caps. ... first they were just the ones near both ends of the DIMM sockets but ... We also had a small number of ATI graphics cards with bad caps. ... Most recently I have found some graphics cards where the heat sink has ...
    (comp.sys.apple2)
  • Re: KV-20EXR10 PS Problem
    ... The power supply board has only three non-electrolytic caps and many ... max brushless fan to the heat sink. ... I want to connect the the fans power leads to the 8 volt d.c. ... A year or two later that converter chip failed. ...
    (sci.electronics.repair)
  • Re: Why put Mylar between a component and its heat sink?
    ... unbolted the 7805 voltage regulator cip from its heat sink, ... a piece of Mylar between them. ... Both sides were coated with heat sink ... used primarily as an electrical insulator. ...
    (rec.games.pinball)
  • Re: Prolonging TV Life
    ... > I clean the inside of my 5 TV's once a year to make sure everything ... > is running cool.I also check all caps for high ESR.. ... > bolt a larger heat sink to the original one.Makes wonders!! ... if he was going to use heatsink compound? ...
    (sci.electronics.repair)