Re: Free Friday: Some laminate and CT tops

One top spoken for. Clarification on tops. My original MsPacCT has an 18
5/8 x 16 inch opening for the monitor with the short sides recessed for the
hardware. The repros are dimensioned as listed with the recess all around
the opening. The outside is the exact same size.

Chris

"cnlmoore" <cnlmoore@xxxxxxxxx> wrote in message
news:2LSdnaZea9xWJMreRVn-1A@xxxxxxxxxxxxxx
>I have one sheet of wilsonart laminate that I purchased to match my Tapper
>CT laminate. Its not a perfect match, but it is a nice woodgrain and a
>quality laminate. Problem for me was that it's to thick to bend, it's
>strictly a flat laminate material. This is a 4'x8' sheet in a large box
>and would be enough to laminate a midway style cocktail table (if you
>bought a kit or had one in pieces made from scratch). Free for pick up
>only. I will ship but its a big box and would most likely cost $20 to $30
>via UPS. No pictures of the grain, sorry.
>
> Also have two reproduction midway style CT tops. I bought them hoping to
> save some time on my ms pacman CT project, but the monitor opening was too
> small. (18" x 14 1/8") My old CT top had a larger opening, maybe they'll
> work on a pac ct or ??? I bought them from one of the kit makers and they
> are decent quality, 1" thick and ready for paint and tmolding. They are
> made from two 1/2" pieces not a single 1" piece. Free for pick up only.
> Again, I'll ship if absolutely necessary but they are big and I don't have
> any boxes handy to fit them. I can wrap them in craft paper or something.
>
> Pick the stuff up for free in Palos Park IL and grab a coin door or
> control panel while you're at it. Call my cell to set up a time.
> 773-858-2096 Chris
>


.

Relevant Pages

  • Re: PC Word docs not accessible in Office X for Mac
    ... it sounds as though possibly the files are opening off the monitor. ... Word file opening off the visible monitor" on the ...
    (microsoft.public.mac.office)
  • Re: (semi OT?) Ikea
    ... We have no IKEA here. ... wood) that was laminated into table tops. ... The table tops were on closeout for $60. ... prep the strips and laminate them to make the tops. ...
    (rec.woodworking)
  • Re: How to open composite monitor //e
    ... something are preventing me from completely opening it. ... These were near the front edge of the monitor. ... All of these screws were in plain view, and there are no evident caps ... While pushing down on the rear panel with one hand, ...
    (comp.sys.apple2)
  • Re: Counter top
    ... DIY laminate jobs are not for the amateur, ... The results from a first time lamination project are rarely ... I did mine because we were going to redo the whole kitchen and get some solid counter tops. ... I installed mine over 3/4" (exterior glue) plywood. ...
    (rec.woodworking)
  • Re: (semi OT?) Ikea
    ... prep the strips and laminate them to make the tops. ... Reminds of the $120 teak porch rockers from Sam's. ...
    (rec.woodworking)