Re: Williams Flash does not with LED's

On Mar 15, 2:30 pm, Jbug <marsh...@xxxxxxxxxxxxxxxx> wrote:
On Mar 15, 1:05 pm, "Lloyd Olson" <l...@xxxxxxxxxxxxxxx> wrote:

Your plus and negative might be different on the socket and bulb. If your
LED is DC. Try switching the wires on the socket. LTG :)

Same thing with my JP.  Terry at Pinball Life said that the wires need
reversing.  Instead of doing each flasher socket individually he
mentioned something about reversing the wires for the whole strand and
it would take care of all the flashers.  I'm waiting to hear from him
on the exact instructions.

You will have to do each socket on the JP unless you reverse each of
the Flasher strings properly to reverse the polarity to get Terry's
bulbs to work. The way the DE machines are wired i dont believe it can
be done any other way. All the Flashers terminate positive at J6 -4/5
Orange wires on the PPB board on the DE machines.

Bruce
www.bcspinball.com
.

Relevant Pages

  • Re: MM flasher stays lit when translite connected?
    ... flasher transistors on the solenoid driver board with a meter. ... Wires you would look for anything shorting to metal (wire, ... You can sort this out a little by unplugging the flasher connector from the ... bad socket? ...
    (rec.games.pinball)
  • Re: Williams Dirty Harry Gun Loaded Flasher??
    ... socket there are 2 metal prongs which I assume should be wired to ... something but there are no wires coming from it....so i'm assuming if I ... In the manual and in the flasher tests ... playfield gun that goes off when the playfield gun gets loaded but it ...
    (rec.games.pinball)
  • Re: Williams Flash does not with LEDs
    ... Try switching the wires on the socket. ... Terry at Pinball Life said that the wires need ... mentioned something about reversing the wires for the whole strand and ...
    (rec.games.pinball)
  • Re: Phone wiring query
    ... socket) in the lounge. ... So the in-house wires were probably done by the builder, ... an other wire went on to the lounge. ... wires back from the master socket? ...
    (uk.telecom)
  • Re: Broadband Speed problems
    ... wires in them. ... The master socket is connected at 4 points: ... If you were to fit a faceplate filter, ... connections, unlike when using Cat-5 cable for LANs ...
    (uk.telecom.broadband)
Loading