Re: Bally Rectifer-Transformer Connection Help Needed!

In article
<7ea5034d-05bf-4c6a-8d6d-4a43c5d0960c@xxxxxxxxxxxxxxxxxxxxxxxxxxxx>,
zak.enyart@xxxxxxxxx wrote:

I recently purchased a new version of the old AS-2518-18 Rectifier
Board from Marco and it came today. I need to be ABSOLUTELY SURE of
the connections that need to be soldered on from the transformer.
There are a lot of wires. I've used my old board as a reference, but
some of the striped wires I'm not too clear on. I figured most of them
out by process of elimination, but I need to verify I have the right
ones... what I have so far is as follows:

E1: Not sure (16ga red)
E2: Thick Yellow (16ga yellow)
E3: Thin Red (18ga red)
E4: Not sure (18ga white/red)
E5: Thin Green (18ga green)
E6: Thin White/Green Stripe (18ga white/green)
E7: Double Thick Blues (2x16ga blue)
E8: Double Thick Blacks (2x16ga black)
E9: Thick Orange (16ga orange)
E10: Thick Green (16ga green)
E11: Thin White (18ga white)
E12: Thin Brown/Black Stripe (18ga white/black)

Also, since I'm not using High Voltage displays, would it be best to
solder on the connection for that one (I'm assuming E5) and just not
put the fuse in, remove it from the transformer entirely (if that's
possible), or just terminate the wire with a cap? If someone can
double-check these for me and fill in the ones I can't determine (I
desoldered these instead of just clipping them) I'd be very grateful!!
Thanks in advance!

Zak

I added the correct wire gauge and colors in the parenthesis by your
list...hope this helps!

-Mike
.

Relevant Pages

  • Re: Mortar question Type S
    ... bus seems to have no strength. ... It is no good in thin layers. ... and the layer has to be thick enough to do so. ... thought bit more water would be of benefit - but apparently not. ...
    (alt.home.repair)
  • Re: Brilliant Idea or Dumb Idea
    ... from the outside makes it semi-obvious how thick or thin the walls ... a "shade" even. ... wall together, you don't need to cut through. ...
    (rec.crafts.woodturning)
  • Re: Ice at the north pole
    ... Peter Skelton wrote: ... 50s to thick in the 90s and and now back to thin but getting thicker. ... area of ice covered and its average thickness. ...
    (sci.military.naval)
  • Bally Rectifer-Transformer Connection Help Needed!
    ... the connections that need to be soldered on from the transformer. ... E5: Thin Green ... E7: Double Thick Blues ... E12: Thin Brown/Black Stripe ...
    (rec.games.pinball)
  • Re: Ice at the north pole
    ... 50s to thick in the 90s and and now back to thin but getting thicker. ... area of ice covered and its average thickness. ...
    (sci.military.naval)