Re: FS:Universal Shaker Kit

Can you clarify, you are running the motor at 12v only? Is the 12V at
the interconnect board unregulated? That motor has a huge startup
current...

Andrew- Hide quoted text -

- Show quoted text -

Andrew,
I can't clarify if it's regulated or not because I have no clue.There
was a open connector at the inter-connect board,on the bottom right
side where there is writing on the board that shows 12v and ground, I
hooked up at that point and it's worked perfect with no problems.
Thanks,
Rob.
.

Relevant Pages

  • Re: Determine switching frequency of photocoupler
    ... I am almost 100% confident that the resistance in the ... With startup current from the ... motor being in the range of 25A+, this causes up to and more than a 1V ... gate drivers. ...
    (sci.electronics.design)
  • Re: TECH: JM hand wont move (almost) at all!
    ... However, at startup the hand tends to move to the left and towards the player, as much as possible and the hand gets stuck again. ... I did try to reflow the solder on the inductor coils in the center of the motor driver board. ... At Y axis it won't even budge from it's position, which appears to be as close to the player as possible. ... It might have said the same for X before but having closed both the switches a few times this is all there's left. ...
    (rec.games.pinball)
  • Re: TECH: Corvette Engine/Motor Driver Slave Board Problem
    ... Does it try to slam the engine over on startup? ... I assume the LED on the motor driver slave board should be on? ... They also read about 21 volts. ...
    (rec.games.pinball)
  • Re: EM TECH Please - Score motor not moving - Need some help
    ... The startup sequence doesn't complete. ... Flicking the coin door switches turns the light on. ... no movement to the motor. ...
    (rec.games.pinball)
  • Re: IE & Spy bot.
    ... Tea timer while installing soft wares gives the following popup ... > messages, such as…..Global startup value added, Active X added, Value ... > number of System.ini are seen checked, could some one clarify their ... Destroy site. ...
    (microsoft.public.windowsxp.general)