Re: DE Star Wars Switch Test
souledge1982 wrote:
when i put the black lead to the non banded and the red to the banded
reading 1 appears. and when i press the switch the same reading
appears.
You can't test diodes in circuit.
http://www.elexp.com/t_test.htm
-scott CARGPB#29
.
Relevant Pages
- Re: Turning a light on and off with momentary switch
... Chris W wrote: ... > I want a circuit that will turn a light on with the press of a ... > switch and then turn it back off when the momentary switch is hit ... > reading, I have found that a flip flop is a much more complex device ...
(sci.electronics.basics) - Re: Turning a light on and off with momentary switch
... > switch and then turn it back off when the momentary switch is hit ... I had heard that a flip flop might be the way to go. ... but it is going to take some more reading before I figure out how. ... and a debounce circuit for your clock input. ...
(sci.electronics.basics) - It LIVES!!!
... Well, after several interruptions, I finally got everything wired up ... paramaters I thought I needed. ... then the main switch to the compressor. ... I'm a little concerned that the oil pressure is reading in the high ...
(rec.crafts.metalworking) - Re: Thermocouple mux 16 ch(4067) + A/D max187
... >i'm building a 16 ch nterface for reading 16 TC type K. ... Conventionally one would use a two CD4067/4051's etc or a CD4052 to switch ... But the AD595 incorporates amplification and ice ... so you would seemingly just need to assure that the thermocouple ...
(comp.home.automation) - Re: testing stand up targets with a DMM
... See the set of two points behind the target, ... You'll get a zero ohm reading or a beep if on ... switch matrix voltage into your DMM on ohms setting. ... with the red lead on the the non-banded diode point and the black lead ...
(rec.games.pinball) |
|
