Tech: MM No High Voltage when turned on.
Fired up my MM for a game last night and the DMD did not come on (it
did previously). I checked the voltages at the display and it is
missing both high voltages. The rest of the game comes on and lights
up. I pressed the start button, but got nothing. Could I be missing
all my high voltage? What should I check if that is the case?
Any clues are appreciated!
Thanks!
John
.
Relevant Pages
- Re: Star Wars w/ Amplifone Monitor, odd issue
... blooming is typically the HV being too low - and with my HV probe I ... pushing the right voltages at it. ... tested the voltages on the game logic, and each of them are good. ... in the event there is some sort of corruption in the game ROMs. ...
(rec.games.video.arcade.collecting) - Re: Williams System 11a Power Supply Issue
... I'm unsure about your AC input voltage- IIRC, this game takes input to the ... Check rectifier while fuses are out of circuit (or input connector is ... You could also have a bad 2N6057 regulator ... I measured the voltages coming from the transformer on the ...
(rec.games.pinball) - Re: Tech help gottlieb system 1 no sound or display.
... You say the game is running so this leads one to suspect ... Have you checked on the power supply fopr the required voltages ... of connector A2P1- cracked solder connection or damaged pin or broken wire. ... Call 872-5757 or Fax 872-2010 (Pinballs, Jukes, Video Games) ...
(rec.games.pinball) - Re: Star Wars w/ Amplifone Monitor, odd issue
... blooming is typically the HV being too low - and with my HV probe I ... pushing the right voltages at it. ... Next the game will play, ... but never actually move any further toward the Death Star - the ...
(rec.games.video.arcade.collecting) - Re: Star Wars w/ Amplifone Monitor, odd issue
... blooming is typically the HV being too low - and with my HV probe I ... pushing the right voltages at it. ... Next the game will play, ... but never actually move any further toward the Death Star - the ...
(rec.games.video.arcade.collecting) |
|
