Re: slot proximity (switch 57)

Dirk wrote:
The switch column and rows are OK. I switched the board with the 26
proximity board and that one works perfect on the 57 location. So the
matrix should be fine right?

When I put the 57 board on the 26 location I have the same problem.
LED is on switch is closed. It must be on the board.

Thanks for your consideration Lloyd but the grief isn't that big I
still have some other great games to play. The thing that bugs me is
that I can't seem to figure it out.


Double check the joints and make sure there's no shorts from solder splatter anymore. It worked for a bit so it can't be that far. I had something similar to you on the TZ except it was the trough proximity board. Turned out to be the wire connector. The headers had lost the lock and as a result, the connection wasn't very good. I replaced the header with new ones with lock and they work 100% now.

Sam
.