Re: Need some Tech Help on a display board(WPC)

On Jun 14, 4:29 pm, tonya111...@xxxxxxxxx wrote:
On Jun 14, 4:13 pm, "John Wart, jr" <johnwar...@xxxxxxxxxxxxxx> wrote:

Check voltages at the xformer

<tonya111...@xxxxxxxxx> wrote in message

news:346ebb6f-2c70-41aa-a6a2-e4733b7e87df@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

Hi guys. I picked up a FT and am trying to figure this out. The board
that is in it would not work. Pulled the board out and took a tested
on in it and it smoked the high voltage. I rebuilt the board again and
thought that I should test the power going into the board and it is
alot higher than my others. What should I look for?- Hide quoted text -

- Show quoted text -

Ok llyod, I went outside and started, I was getting different
readings. I started to look at the connector that comes from the
toggle. Now both are domestic machines and the pins are different.
Should they be pinned the same?

Sorry John, ment to say it but spelled different, LOL
.

Relevant Pages

  • Re: Need some Tech Help on a display board(WPC)
    ... on in it and it smoked the high voltage. ... I started to look at the connector that comes from the ... toggle. ... Now both are domestic machines and the pins are different. ...
    (rec.games.pinball)
  • Re: changing the fan cooler on my video card
    ... In other words, the labels that you can read what the connector says are pointed inwards on the inside pins and the connectors on the outside closest to the edge of the mobo, those labels are pointing towards outer most edge. ... as you can throw off the color purity with magnets nearby. ... The Azalia has plug sensing signals, which is the difference from AC'97. ...
    (microsoft.public.windowsxp.hardware)
  • Re: 3B1 will not boot from Diagnostic Floppy
    ... -- but the hard disk drive has its own cable from the power supply. ... I have had the power connector go unreliable even on a 3B1 with ... Other pins provide the +12 VDC (Disk drives, monitor, and the ... If you see this, flow fresh solder into the affected joint, use ...
    (comp.sys.3b1)
  • Re: GPS problem
    ... It should show continuity on each line/pin. ... There are only 4 pins on the Garmin unit. ... and there is NO connector in the cable. ... >> solid enough without a screw in place, and it looks like a fairly small ...
    (microsoft.public.pocketpc)
  • Re: Tech help gottlieb system 1 no sound or display.
    ... I have checked the pins to the soundbord and it looks ok. ... Have you checked on the power supply fopr the required voltages ... that you have to use the common on the same connector for verifying ... I did meassure the pins on the A1-P1 connector and the 2 last pins ...
    (rec.games.pinball)