Re: How to remove a pop (jet" bumper from a CV?

Power off. Unsolder wires, pull the socket up and out. Two 5/16" nuts hold
the metal rods to the fiberboard/metal plunger holder parts, three 5/16"
nuts hold the coil bracket to the playfield. Two phillips head machine
screws hold the coil to the bracket. Not hard, a little time consuming. LTG
:)

"planters49" <planters49@xxxxxxxxx> wrote in message
news:97f02d31-6dcd-4118-b088-785eda240e2b@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
One of the pop (jet) bumpers on my Cirqus Voltaire is totally trashed
below the playfield. The coil is dead and the part with the two metal
rods is broke. I ordered new parts to repair the pop bumper. What's
the best way to remove the pop bumper from the playfield. It looks
like the light socket is stapled to the underside. What's the best
way to remove it?



.

Relevant Pages

  • Re: 1/4 inch socket, back nuts (black plastic)
    ... sockets plus nuts. ... I've run out of salvaged ones to replace the missing ... electronic hints and repair briefs, ... A brand new jack socket with nut costs 50 pence. ...
    (sci.electronics.repair)
  • Re: Wanted: socket for square nuts
    ... > pole and slide into slots in the base where they're secured by square ... > square nuts. ... > normal open-ended or adjustable wrench onto them. ... > So what I need is a four-point socket but unfortunately I don't see ...
    (rec.crafts.metalworking)
  • Re: On the subject of bikes and tools.
    ... >> steering wheel nuts and suspension towers please? ... > Or the 15mm socket head I had to buy, to undo tappet block nuts, ... 15mm cone spanners, I seem to use them quite a lot, when I'm working ...
    (uk.rec.motorcycles)
  • Re: Ridgid 3560 installation notes...
    ... if you want to use that size make it socket accessible. ... A good reason to use metric. ... I argued for two years with our mold setup guys that the nuts on some ... combination metric wrenches (round on one end, ...
    (rec.woodworking)