Re: Playboy (1978) Dead Flipper

On May 29, 11:36 am, "♥ F<(*¿*)>M ♥" <I.hate.the.Cowb...@xxxxxxxxxx>
wrote:
homebrood wrote:
On May 28, 8:00 pm, btho...@xxxxxxxxxxxxxxxxx wrote:

Right flipper does not fire at all. Left flipper is fine. Have good
continuity through wiring to lightbox. Connector and pin header are
rock solid. Is there a transistor on the solenoid drive board that I
need to replace?

Sounds to me like it may be the flipper relay on the Solenoid Driver/
Regulator board.

Could also just be the end of stoke switch is not making contact ...

Your village called homebrood. They want their idiot back.

Fixed!!! It was a bad solder connection on a pin header running to
the flipper relay. Thanks everyone. I'm back to being my kids'
hero. Next project - the Night Moves sit-down pinball game. I'm sure
I'll have more posts
.

Relevant Pages

  • Re: Playboy (1978) Dead Flipper
    ... Connector and pin header are ... rock solid. ... Is there a transistor on the solenoid drive board that I ...
    (rec.games.pinball)
  • Re: What is this Amdek card??
    ... RGB style inputs, such as SCART. ... D connector on the back. ... with a rather large card and a daughter card with an 8 pin output. ... My card doesn't have the 10 pin header, only the 16 pin header, and only two switches in the dip-switch. ...
    (comp.sys.apple2)
  • FC3 - 64 bit on Gigabyte GA-K8NPRO
    ... Internal I/O Connectors ... 2 x Serial ATA connector ... S/P DIF input/output pin header ...
    (Fedora)
  • Re: Hi speed USB PCB layout
    ... spec's requirements by enough to give you some flexibility. ... recent board puts high-speed USB over a 1mm-pitch pin header to a ... connector, and it seems to work (the tracks are maybe 5cm long and are ...
    (sci.electronics.design)
Loading