Re: tech: WH20 big foot motor wires came off

On Apr 2, 8:59 pm, erickitr...@xxxxxxx wrote:
On Apr 2, 6:50 pm, appetite4pinball <mgsiev...@xxxxxxxxx> wrote:

In the process of shopping out my WH20; the yellow and red wires that
attach to the big foot motor managed to come loose and i'm not sure
which wire goes to which lug of the motor now? Anybody have a pic of
this of the underside of the upper playfield, or a WH20 that is
disassembled that could check this out so that i can solder these back
on correctly? thank you!
Mike

Red is closest to the pins in the board.
Email me for pic.

Eric

Thanks again Eric, for helping me out! Your upper playfield upkick
fix also helped me out a couple weeks back!
Mike
.

Relevant Pages

  • Re: tech: WH20 big foot motor wires came off
    ... attach to the big foot motor managed to come loose and i'm not sure ... which wire goes to which lug of the motor now? ...
    (rec.games.pinball)
  • Re: tech: WH20 big foot motor wires came off
    ... attach to the big foot motor managed to come loose and i'm not sure ... which wire goes to which lug of the motor now? ...
    (rec.games.pinball)
  • Re: tech: WH20 big foot motor wires came off
    ... attach to the big foot motor managed to come loose and i'm not sure ... which wire goes to which lug of the motor now? ... this of the underside of the upper playfield, ...
    (rec.games.pinball)
  • Where to buy GI wiring braid/wire and picture of GI needed
    ... GI wire broke on my Flash that supplies the upper playfield (1-2-3-4 lanes, ... fuse card and had no GI lighting at all. ...
    (rec.games.pinball)
  • WW GI PROBLEMS
    ... Problem - I have no upper playfield GI lights white / brown wire. ... Pin 2 - the wire was cut and a yellow wire was spliced in. ... I assume the low voltage is my problem. ...
    (rec.games.pinball)