Re: Playfield underside stripping advice needed.



I am about to do the same thing
but when I remove the mechanics of each part (eg Pop Bumpers) I am
going to leave the solenoid soldered in place and use a cable tie to
fasten it to the wiring loom so that it wont break off
even though I have taken lots of pictures I know it will be a good 6
months before I am ready to put it back together, I am trying to give
myself every advantage
.

Relevant Pages

  • Re: EM bumper wiring advice.
    ...  Several cut wires are connected back together with banana clips ... It looks like a previous owner was trying to "upgrade" the pop bumpers ... Step two rebuild the pop bumper mechanics - that should be more than ...
    (rec.games.pinball)
  • Re: Playfield underside stripping advice needed.
    ... but when I remove the mechanics of each part I am ... Put Molex connectors on every solenoid.makes the harness way easier ... Lots of pictures. ... Clean one box of parts at a time and transfer ...
    (rec.games.pinball)
  • Help - MM under playfield pop bumper pix
    ... take pictures of the wiring. ... I know, stupid. ... me a picture showing which wires go to which pop bumpers? ...
    (rec.games.pinball)
  • TOTAN prototype playfield?
    ... I noticed an unpopulated switch slot in ... the right orbit below the pop bumpers. ... pictures I found were missing this slot. ...
    (rec.games.pinball)
  • Re: CNC on the cheap
    ... The pictures you made would ... > suggest to make the mechanics with Fischer Technik (the ones that make ... It's more like Lego on steroids for us mechanics. ... Prev by Date: ...
    (rec.crafts.metalworking)