Re: Tech,Gottlieb Sys 3 Problem

For #1 -- Sounds like you have no load on the 48VDC power.
With no load -- you will normally see roughly 50V x 1.414 or about 70VDC.

-- Ed


<conkl@xxxxxxxxx> wrote in message
news:29563-47A53331-1524@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
Question #1 - Bridge rectifier that supplied 48 Volts DC is reading 70
Volts DC. 51 Volts AC input reads fine. I replaced the rectifier and my
readings are still the same. Any ideas where the additional voltage is
coming from?

Question #2 - At machine power up several of the solenoids on the
playfield are engaging. AC fuse F7, 8 amp slowblo will blow ater about 3
seconds. Is this a driver board issue? If not, any other suggestions?

Lee Conklin.
P.O Box 208 Jugg Street
Moravia,New York 13118
http://community.webtv.net/conkl/SomeofCONKS
http://members.tripod.com/~andybauch/magic.html



.

Relevant Pages

  • Is this ~150W 12V dc-dc supply realistic?
    ... >I just got done designing a new DC-DC power supply that takes in 6-20 ... volts the output load can be 10 amps sustained, ...
    (sci.electronics.design)
  • Re: 12v TV
    ... what was being pointed out is that the mains power supply outpts 12 volts... ... hence the TV's components are made using the lowest tollerance parts available, no need to use more expensive higher voltage parts when the TV will never see more than 12.3 volts. ... as a fair few people found out tho, plugging it into the caravans battery directly... ... i have a large solar array on my vans roof, and it does an equalizing charge every month, takes the batteries upto 16 volts for a few hours to balance them all out and stir up the cells, my Tv would have let the magic smoke out first time it did that for sure. ...
    (uk.rec.caravanning)
  • Re: He who laugh last, laughs loudest, was Re: Wet your pants funny-- A.J. as an EE
    ... if you look at the LM675 spec sheet it shows 90db of power supply ... If the power supply voltage varies ... going to get 60 volts peak-to-peak out, which is about 20 volts RMS ... So this added resistor has used up all the IC's power ...
    (rec.audio.tubes)
  • Laughing even louder at the "engineers", thanks Old Hack Re: He who laugh last, laughs loudest, was
    ... if you look at the LM675 spec sheet it shows 90db of power supply ... If the power supply voltage varies ... going to get 60 volts peak-to-peak out, which is about 20 volts RMS ... So this added resistor has used up all the IC's power ...
    (rec.audio.tubes)
  • Re: Need "constant voltage-drop device"
    ... voltage drop between a DC power source and its Load over a very wide ... I would need something that maintains a voltage ... drop of, say, 100 volts while the power supply output fluctuates from ...
    (sci.electronics.design)