I am also looking for pads and repair eyelets to replace the GI on WPC.
I have picked up a few kits but nothing that big.. :(
Jack James
Ron - NY wrote:
2 questions:
When soldering a PCB with traces on both sides of the board, do you need to
use flux paste ? I'm afraid if I don't use it, I'm not getting a good solder
connection on both sides.
When de-soldering a pin on a burnt connector like a G.I connector etc, many
times the round donut trace comes off. Can you buy just the round
replacement pads and stick one on there and solder it in place ? I could
swear I saw these somewhere and now I can't find them. Anyone know what I'm
talking about ?
thanx
Ron
Re: Hand reworking SMT mictors? ... thickness of the stencil means the connector won't seat properly. ... with a small screwdriver and solder the pin by hand then mash the ...Heat the board gently with a paint stripper to remove ... clean the pads using desoldering braid. ... (sci.electronics.design)
Re: Hand reworking SMT mictors? ... thickness of the stencil means the connector won't seat properly. ... with a small screwdriver and solder the pin by hand then mash the ...Heat the board gently with a paint stripper to remove ... clean the pads using desoldering braid. ... (sci.electronics.design)
Re: tech help, soldering and pad repair ... When soldering a PCB with traces on both sides of the board, ... a good solder connection on both sides. ... When de-soldering a pin on a burnt connector like a G.I connector etc, ... many times the round donut trace comes off. ... (rec.games.pinball)
tech help, soldering and pad repair ... When soldering a PCB with traces on both sides of the board, ... I'm afraid if I don't use it, I'm not getting a good solder... When de-soldering a pin on a burnt connector like a G.I connector etc, ... times the round donut trace comes off. ... (rec.games.pinball)
Re: MCX connector repair (in UK) (only vaguely on topic I admit) ... I've accumulated several crimping handles and a number of the die sets over the years purchased at retail). ... you can see the approx O.D. of the various coax sizes.... Sliding the connector on can create a slightly expanded section where the connector slides down between the dielectic and the braid and the sheath. ... The process is to cut and trim the coax to the lengths shown and tin the exposed tip of the center conductor with a little solder.... (sci.geo.satellite-nav)
