Re: Easy one for you tech guys -

On Dec 7, 9:55 am, beaver <e...@xxxxxxxxxxxx> wrote:
Think of water flow.

If you put a valve inline with a water meter, it does not matter if
you put the valve on the high pressure side or the return side. You
can control the flow in the same way in both cases.

The pressures will be different between the valve and the water meter,
but the flow will be dependent only on the opening of the valve.

Edward Cheung CARGPB26

On Dec 7, 9:24 am, badta <dhor...@xxxxxxxxxxxxxx> wrote:



I posted yesterday about connecting an led to the flasher circuit
(Thank you Ed Cheung for your response).
I've done a little more web reading and basically it comes down to
this, from what I understand.
I'll connect a resistor to the cathode (negative) leg of the led. The
hot wire will go to the anode (positive) leg. the ground wire will
then be connected to the other end of the resistor. Simple enough.
Heres my question - how can the resistor be limiting the power if its
not between the "hot" wire and the led???

Perplexed- Hide quoted text -

- Show quoted text -

But why doesnt the led blow if the resistor is not in line BEFORE it?
.

Relevant Pages

  • Re: Easy one for you tech guys -
    ... you put the valve on the high pressure side or the return side. ... I'll connect a resistor to the cathode leg of the led. ... hot wire will go to the anode leg. ...
    (rec.games.pinball)
  • Re: Easy one for you tech guys -
    ... Think of water flow. ... you put the valve on the high pressure side or the return side. ... The pressures will be different between the valve and the water meter, ...
    (rec.games.pinball)
  • Re: Anyone familiar with early hydraulic steering systems?
    ... >pressure return hose from the reservoir and stick the end back into the ... >tester is a high pressure valve with a gage between the valve and the pump. ... In the linkage-type power steering gear the power cyl is not part of ...
    (rec.crafts.metalworking)
  • Re: Hot water boiler pressure high
    ... It has been running at a high pressure and this is causing the pressure relief valve to release water. ... It is an old system with no compressed air in the tank, which I believe does not have a bladder in the tank. ... The pressure relief valve does go off due to the high pressure, but does seem to seat well after the pressure goes down. ...
    (alt.home.repair)
  • Re: Damn... I may be turning into a DIR Nazi ;-)
    ... valve instead: its either straight in line, ... pressure gas that quickly is dangerous. ... s***t out of the high pressure seats in the regs. ...
    (rec.scuba)