Re: TSPP reset problem

You may have AC power issues with something else taxing the circuit the pin
is on.

--
-cody
CARGPB4


"fatchoumakou" <fatchoumakou@fat> wrote in message
news:4735e547$0$6133$426a74cc@xxxxxxxxxxxxxxx
The problem seems to be resolved today.
I haven't got resets anymore. It's a mystery because I didn't do anything
to fix the problem ...

Thank you all for your help

"fatchoumakou" <fatchoumakou@fat> a écrit dans le message de news:
4734e40d$0$5266$426a74cc@xxxxxxxxxxxxxxx
Since a few days my TSPP restarts randomly. How could I solve this
problem ?

Regards,
Nicolas





.

Relevant Pages

  • Re: WTB: Power supply for Heathkit "home" version of Fireball (Bally?)
    ... pin work in this Fireball home version pin. ... I also had to build a pass through circuit ... that carried fuses and returned back to the board for the 22v (coils ... board and then go directly off board again through fuses. ...
    (rec.games.pinball)
  • Re: decoupling caps placement
    ... I've got a circuit that uses 3 4049 inverters. ... pin 8 and the ground is on pin 1. ... sufficient to connect 1 end of the cap to V+ and the other to a nearby ... If building on veroboard or solderless breadboard, make sure you have reliable power and ground rails. ...
    (sci.electronics.basics)
  • Re: TECH: System 11 High Speed - Any LEON Test for Special Solenoids and Flippers
    ... All special solenoids fire if I ... U56 is also outputting a low signal on pin 6 no matter ... the 7406 inverter with pins 5&6 in the "game up/game over" circuit is U56. ... So if you are running / testing the board in game you *must* remove the Solenoid fuse F2 on the PSU board for this test. ...
    (rec.games.pinball)
  • Re: Lynskey Helix
    ... still using those archaic electrical plugs that y'all invented. ... then safely carried by a 1.3 mm2 pin. ... apparently one leg of a circuit carries twice the ... from the circuit leg to ground, through the ground pin. ...
    (rec.bicycles.tech)
  • Re: SyncMaster 151s LCD monitor turns itself completely off after 20 minutes
    ... This IC has a built-in thermal shutdown latching circuit for when it is ... UC3842 PWM IC, there are a couple ... V or pull pin 1 below 1 V, ...
    (sci.electronics.repair)