Re: TECH: Strange problems with playfield lights (none/some/flickering) on my T2



On Oct 1, 9:09 am, firepower <harve...@xxxxxxxxxxxxx> wrote:
Scratch that - before someone jumps in and says so, I've got the wrong
era machine. WPC doesn't use the 6821 PIA anymore. It has the
dreaded WPC- ASIC chips and other horrible nasties. I prefer the
"simpler times" model where you can get at and repair some of the
problems these games have.

Best left to a professional - which is not me in this case!

BTW - What I said about cables still applies. Reseat cables between
CPU and Sound / Driver boards.

Cheers

-Richard

If reseating a connector (other than ribbon cables)
"fixes"/changes any problems, all you have is identify the
problem. a re-seat is not a fix. Now the ribbon cables
are a different animal, and yes i would suggest a
reseat of those, and if that "fixes" anything, then stop
there and call it good. But on .156" molex connectors,
a reseat "fix" just identifies a problem, and the connector
should be re-pinned.

When you say the lights flicker, do you mean
the GI or the computer controlled game lights
(like bonus numbers, etc)?

if it's the GI (which i think is what you're talking
about), chances are excellent that the GI
connectors on the driver board j120/j121
are cooked and needed to be replaced.

if it's the CPU controlled game lights, that's
different. i would suspect a cracked plated
thru hole for it's bridge rectifier as that problem
(or maybe the fuse/fuse holder).

.



Relevant Pages

  • Re: Mackie D8B
    ... connector from the back of the console, wait a few seconds then plug it ... back in & power up. ... clean the contacts and reseat them. ... problem, replaced the cable, reseated the cards and it went away.- ...
    (rec.audio.pro)
  • Re: is this a bad hard-drive?
    ... failed Seagate. ... Some ribbon cables on HD's will plug in reversed. ... The ide connector might be labeled on the drive circuit board as to which end of the connector is pin 1 and which is pin 40. ...
    (microsoft.public.windowsxp.hardware)
  • Re: WH2O just wanted some attention
    ... fuses and check them. ... Just great now I get garbage on the DMD and the game won't boot. ... reseat all the ribbon cables. ...
    (rec.games.pinball)
  • Re: 32X question
    ... The 32X is notoriously flakey and unreliable. ... The standard fix for many ... 32X problems is to reseat two ribbon cables inside the machine. ...
    (uk.games.video.misc)
  • Re: TECH - TZ resets AGAIN!
    ... new connectors/pins, all new ribbon cables. ... NOT at the connector but the legs on the board. ... wierd was replaced in the ball trough opto board other than the ... make sure the cpu board headers for the supply in is good. ...
    (rec.games.pinball)