Re: Source for GNR Bumper Posts (530-5127-00)?

530-5127-00 shows as NLA from Stern. It seems to be a rare #6-32 post with a
#6-32 Tap on top. Most all the other posts are #8 or #10 size mounting. If
#10 Mounting will work (need to ream out the hole and if there is space for
a #10 nut, then 530-5679-00 might work or #530-5332-01 but that looks a
little thicker and a little taller. I think a similar situation with WMS
parts as well, couldn't find one similar with a #6/-32 based

rick@xxxxxxxxxxxxxxxxxxxxx


.

Relevant Pages

  • Re: What is correct method?
    ... >>holes should be part of a chassis ground net, is it proper to give ... >what to do with this mounting hole. ...
    (sci.electronics.cad)
  • Re: Dogs dogs dogs
    ... so anything that may happen (pretty rare and always trying ... to get at a critter) gets fixed without much fanfare. ... accidentally put one wheel on the lawn tractor into a husky ... hole and had to tow it out with the quad because the hole ...
    (rec.pets.dogs.health)
  • Re: Mounting An LCD TV
    ... than the original TV and, while it won't fit in the same hole, it ... hole bolt pattern on the back to be used for wall mounting but the ... bolts look to be a shade smaller than 8/32. ... Just put an L the width of the screen on the bottom of the board you ...
    (rec.outdoors.rv-travel)
  • help drilling G10 board?
    ... Any advice on drilling G10 board? ... I've got a turret board with no mounting ... I have no experience working with this material. ... Or do I make the hole in one pass. ...
    (alt.guitar.amps)
  • Re: help drilling G10 board?
    ... >>Any advice on drilling G10 board? ... >>enlarging to fit the #6 mounting post? ... Or do I make the hole in one pass. ... That works for the crosscut blades, ...
    (alt.guitar.amps)