Re: Rework station - opinions wanted

On May 17, 4:22 pm, buzz66 <b...@xxxxxxxxxxxxxx> wrote:
Anyone who lifts tracks with solder wick, shouldn't be allowed to
touch a PCB, let alone 350 degree soldering iron!

The only problem with solder wick, is people use the no clean type
wick instead of the "rosin type"

I have 23 years experience working on every type of PCB.
Time to make a post an educate some people here how it really should
be done


23 years experience, sure. But were you taught properly or did you
just kinda figure it out on your own?
Theres a right way and a wrong way to lots of things.... then theres
my way....
:)
kj

.

Relevant Pages

  • Re: Rework station - opinions wanted
    ... let alone 350 degree soldering iron! ... The only problem with solder wick, is people use the no clean type ... I have 23 years experience working on every type of PCB. ... You can still be unable to repair boards and have 30 yrs ...
    (rec.games.pinball)
  • Re: Rework station - opinions wanted
    ... let alone 350 degree soldering iron! ... The only problem with solder wick, is people use the no clean type ... I have 23 years experience working on every type of PCB. ...
    (rec.games.pinball)
  • Re: how to remove lqfp package
    ... >clip them off with cutters and then clean up the pads with a soldering iron. ... There is a material sold for removing such things with no damage at all. ... the solder freeing the IC without even the slightest damage to the PCB. ...
    (sci.electronics.design)
  • Re: wanted burgertime manual and schematics
    ... Problem is I have no vertical sync leaving the pcb. ... Soldering iron is heating up right now. ... What is the problem with your game right now or are you building one? ...
    (rec.games.video.arcade.collecting)
Loading