Re: GI problems WCS

Nope- that was a solder splash between 2 pins. Back to sqaure one
"Tony Holdgate" <tonyholdgate@xxxxxxxxxxx> wrote in message
news:46061f34$1@xxxxxxxxxxxxxxxxxxxx
Nope- I think you were right the first time. Under GI test the left side
comes on with both left and right tests!
So I need the wire colurs for J121. I'll post a seperate request

Thanks Doug

Tony
"Tony Holdgate" <tonyholdgate@xxxxxxxxxxx> wrote in message
news:46061b4e@xxxxxxxxxxxxxxxxxxxx
Could be a wrong wire but it was working- it has only just failed. I
have buzzed out the plug as well and I know both the header pin and the
plug are fine. I have reflowed all the solder joins again and still no
joy.

Can a triac fail under load? Or perhaps the transistor? I 've never seen
that behaviour from either but I am starting to grasp at straws
"Kansas Pinball" <oldsrulez@xxxxxxxxx> wrote in message
news:1174800092.520076.248240@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I haven't really looked into it schematics-wise, but if you say you
shorted it and it works fine, but when you put the connector on, it
fails, my mind immediately starts to go down the path of bad pin,
incorrect color wire in incorrect hole (maybe accidentally moved it
over one) type scenarios. You said you put a new connector on. Check
your wire colors and pin numbers to ensure your not moved over or
incorrect.

Doug
CARGPB #32







.

Relevant Pages

  • Re: GI problems WCS
    ... So I need the wire colurs for J121. ... buzzed out the plug as well and I know both the header pin and the plug ... incorrect color wire in incorrect hole (maybe accidentally moved it ...
    (rec.games.pinball)
  • Tech: B&K 465 conversion help needed. Long post
    ... switch in the R position and selecting the guns with the SP-65. ... pin 3 - NC ... I'd like to hardwire this grey harness to a 12 pin molex connector to be ... Rewire the color socket assembly, each socket has a green wire on pin ...
    (sci.electronics.repair)
  • Re: Fast removal of FBTs Was: De-soldering ICs with a hot air gun.
    ... transformer using a paint stripper gun. ... I very rarely use this SMD technique for more than 16 pin DIL format but it ... Note the residual patterning in the solder, on the board, makes it a doddle ... Form a ring of silicone covered wire around the IC{to isolate the remaing ...
    (sci.electronics.repair)
  • Re: Foxconn 661FXME IT DOESNT POWER UP
    ... The second power connector, is for the processor. ... you also need to wire up the power button ... You can rotate the pin pair ...
    (alt.comp.hardware.pc-homebuilt)
  • Re: TECH: Corvette Engine/Motor Driver Slave Board Problem
    ... Maybe I did something when I soldered the wire on temporarily. ... I will get an angled screwdriver tomorrow and take off the engine cover on ... I tested the "sense" pin on the connector to the hall sensor. ... I assume I can add a wire from R37 to the ...
    (rec.games.pinball)