Re: GI problems WCS

Nope- I think you were right the first time. Under GI test the left side
comes on with both left and right tests!
So I need the wire colurs for J121. I'll post a seperate request

Thanks Doug

Tony
"Tony Holdgate" <tonyholdgate@xxxxxxxxxxx> wrote in message
news:46061b4e@xxxxxxxxxxxxxxxxxxxx
Could be a wrong wire but it was working- it has only just failed. I have
buzzed out the plug as well and I know both the header pin and the plug
are fine. I have reflowed all the solder joins again and still no joy.

Can a triac fail under load? Or perhaps the transistor? I 've never seen
that behaviour from either but I am starting to grasp at straws
"Kansas Pinball" <oldsrulez@xxxxxxxxx> wrote in message
news:1174800092.520076.248240@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I haven't really looked into it schematics-wise, but if you say you
shorted it and it works fine, but when you put the connector on, it
fails, my mind immediately starts to go down the path of bad pin,
incorrect color wire in incorrect hole (maybe accidentally moved it
over one) type scenarios. You said you put a new connector on. Check
your wire colors and pin numbers to ensure your not moved over or
incorrect.

Doug
CARGPB #32





.

Relevant Pages

  • Re: GI problems WCS
    ... Nope- that was a solder splash between 2 pins. ... So I need the wire colurs for J121. ... have buzzed out the plug as well and I know both the header pin and the ... incorrect color wire in incorrect hole (maybe accidentally moved it ...
    (rec.games.pinball)
  • Re: GI problems WCS
    ... Could be a wrong wire but it was working- it has only just failed. ... buzzed out the plug as well and I know both the header pin and the plug are ... incorrect color wire in incorrect hole (maybe accidentally moved it ...
    (rec.games.pinball)
  • Tech: B&K 465 conversion help needed. Long post
    ... switch in the R position and selecting the guns with the SP-65. ... pin 3 - NC ... I'd like to hardwire this grey harness to a 12 pin molex connector to be ... Rewire the color socket assembly, each socket has a green wire on pin ...
    (sci.electronics.repair)
  • Re: Fast removal of FBTs Was: De-soldering ICs with a hot air gun.
    ... transformer using a paint stripper gun. ... I very rarely use this SMD technique for more than 16 pin DIL format but it ... Note the residual patterning in the solder, on the board, makes it a doddle ... Form a ring of silicone covered wire around the IC{to isolate the remaing ...
    (sci.electronics.repair)
  • Re: Foxconn 661FXME IT DOESNT POWER UP
    ... The second power connector, is for the processor. ... you also need to wire up the power button ... You can rotate the pin pair ...
    (alt.comp.hardware.pc-homebuilt)