Re: GI problems WCS

Could be a wrong wire but it was working- it has only just failed. I have
buzzed out the plug as well and I know both the header pin and the plug are
fine. I have reflowed all the solder joins again and still no joy.

Can a triac fail under load? Or perhaps the transistor? I 've never seen
that behaviour from either but I am starting to grasp at straws
"Kansas Pinball" <oldsrulez@xxxxxxxxx> wrote in message
news:1174800092.520076.248240@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
I haven't really looked into it schematics-wise, but if you say you
shorted it and it works fine, but when you put the connector on, it
fails, my mind immediately starts to go down the path of bad pin,
incorrect color wire in incorrect hole (maybe accidentally moved it
over one) type scenarios. You said you put a new connector on. Check
your wire colors and pin numbers to ensure your not moved over or
incorrect.

Doug
CARGPB #32



.

Relevant Pages

  • Re: GI problems WCS
    ... So I need the wire colurs for J121. ... buzzed out the plug as well and I know both the header pin and the plug ... incorrect color wire in incorrect hole (maybe accidentally moved it ...
    (rec.games.pinball)
  • Re: Breakshot help--plug check needed...
    ... Would someone be kind enough to check the color wiring order on the Power ... Driver Board at plug J-124? ... Wire colors for J24 are as follows....all are red and another color so ... Pin 1 Blank ...
    (rec.games.pinball)
  • Re: Why does my TZ shock me?
    ... rails to the ground pin on the plug. ... Be sure game is wired right. ... plug outlet you have a live wire, ... Without this wire you could walk up to a pin ...
    (rec.games.pinball)
  • Re: GI problems WCS
    ... Nope- that was a solder splash between 2 pins. ... So I need the wire colurs for J121. ... have buzzed out the plug as well and I know both the header pin and the ... incorrect color wire in incorrect hole (maybe accidentally moved it ...
    (rec.games.pinball)
  • Re: Plugs for lighter sockets?
    ... the wire to the centre pin, ... melt the solder is quite high, high enough to melt the plastic in ... Did you try dismantling the plug before soldering...? ... the end of the pin where the wire should go just ...
    (uk.rec.driving)