Re: Brian Eddy VS Other Pinball Designers



It seems Brian likes to have that campy humor in his pins which is done
really well. The designs and shot layouts are laid out neatly on his pins.
From a tech standpoint they are easy to work on. The DMD animations on his
pins are some of the best. I still love Pat's TZ, FH and TAF though.

Mike
www.HabosArcade.com


"GarageDoor" <generalemailaccount@xxxxxxxxxxx> wrote in message
news:1151843696.373990.7170@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx
When Brian Eddy hangs around with the other pinball designers, assuming
he does, do you think he ever considers himself cooler than them for
the mere fact that he designed MM and that game is so highly sought
after right now? I mean, he deserves bragging rights, right? No
offense to the others, but they didn't exactly design Medieval Madness
now did they. So, if he came to your pinball party would you give him
a beer before Pat, or Dennis, or even GOMEZ!



.



Relevant Pages

  • Re: A small rant about the 555 :-)
    ... I never draw schematics with the pins arranged in physical order. ... I was thinking the other day about how some analog devices, like 741, ... My designs from the '60's can still be purchased... ...
    (sci.electronics.design)
  • Re: Strange MOSFET driver behaviour - Microchip TC4426
    ... made it into my designs is an I2C EEPROM). ... what happened with a series 10 Ohm resistor, ... the driver output the initial perhaps 1/5th or 1/4th of the voltage ... pins, at the bottom side of the board. ...
    (sci.electronics.design)
  • Re: Strange MOSFET driver behaviour - Microchip TC4426
    ... made it into my designs is an I2C EEPROM). ... what happened with a series 10 Ohm resistor, ... Ground bounce if any will be solely inside the chip, ... pins, at the bottom side of the board. ...
    (sci.electronics.design)
  • Re: Strange MOSFET driver behaviour - Microchip TC4426
    ... made it into my designs is an I2C EEPROM). ... what happened with a series 10 Ohm resistor, ... the driver output the initial perhaps 1/5th or 1/4th of the voltage ... pins, at the bottom side of the board. ...
    (sci.electronics.design)
  • Re: Tech - TAF wiring question - J101, 115, 120 and 121
    ... The manual should have those all laid out. ... Find the power drive board diagram with all the pins and their wire colors ... The Wpcs have some loops on J115 and J101. ... J120/121 has no loops and is very straightforward. ...
    (rec.games.pinball)