Re: TECH: Strange Shadow magnet problem

OK, the voltage is around 51V when the coil is inactive. The same for
the high side. When the coil is active it seem to be somewhere around
46V, though it is hard to make a good measure when you first have to
put the ball on the magnet.

.

Relevant Pages

  • Re: Does an electromagnet lag its input?
    ... the pull of the magnet will lag the input voltage by ... Those also contribute to the magnetic force, but they are not in phase with the coil current. ...
    (sci.electronics.basics)
  • 1956 Williams woodrail questions
    ... I'm wondering about how to clean the plunger gauge (not sure if that's ... Ball release coil: On this machine the ball release coil is mounted under ... that controls whether high voltage or low voltage goes into it, ...
    (rec.games.pinball)
  • Re: What would cause a new spark plug to die so quickly?
    ... How could they get a coil ... accept the disadvantage of lower voltage output. ... engine so powerful that it would take God's Own Lightning to fire the ... spark plug, so they went after high voltage coils that put out as much ...
    (rec.motorcycles.tech)
  • Re: Electrical Insanity with 87 CBR600
    ... I have never had a pulser coil failure on any vehicle that I have ever ... typically they will just have a coil around a magnet mounted stationary with a steel/iron rotating part. ... What happens is when rotating plate puts a hunk of itself near the pick up, it disturbs the magnetic field which produces a voltage change in the pickup coil. ...
    (rec.motorcycles.tech)
  • Re: Capacitor bank pretty well complete
    ... Charge them with line voltage and discharge into ... short the terminals through a coil. ... will make some generous magnetic field, maybe I can shoot an aluminum plate ... A capacitor is the opposite of an inductor. ...
    (sci.electronics.design)