Re: Tech: Very odd System 11 Board. Can you identify

If I were in your shoes, I would proceed by shining a bright light
through the board to trace where the wires for the DIP switch go. Then
use the schematic of a System 11 board to correlate that to jumpers so
that you can understand the desired state.

I would be glad to help further if you wish.

Edward Cheung

.

Relevant Pages

  • Re: Todays what the heck is it? item...
    ... A friend of mine recently had to trace down a couple of short circuits ... breaker box between the two wires which were showing a shorted load. ... tone to figure out where the wires were running inside the drywall. ...
    (sci.electronics.repair)
  • Re: 10/100BaseT Impedance Mismatch
    ... the impedance is a function of the trace width, ... >> characteristic impedance. ... wires from the incoming Ethernet twisted pair wire to one of such ... This arrangement would give you 100 ohms differential ...
    (comp.dcom.lans.ethernet)
  • Re: 16-volt CB125RS
    ... There's a sort of plastic box, a bit like an elongated matchbox, with ... three wires coming out of it, under the tank on the right, and it's ... The that must be the rectifier. ... makes for a nice bright light, though, for a while. ...
    (uk.rec.motorcycles.classic)
  • Re: wire sizes
    ... The Cat 5 cable has the twisting of the pair optimized so that it can ... base and the "trace" color. ... At the 4 pair level (8 wires) I think they still just use solid colors. ... Bell System practice is blue white is line 1, ...
    (alt.home.repair)
  • Re: Apple IIc plus RGB video?
    ... passes through a pair of plastic rings and loops around twice. ... tomorrow, if anyone is interested, I can trace the wires. ...
    (comp.sys.apple2)